a l l   w i t h   w i n d o w s

 

 

.

1119

 

Hovercraft

sr.n1

hovercraft sr.n1 - 1119

page last updated: 22 February 2017


 

 Follow Little_Wheels on Twitter

I think we had one of these when I was a kid at home - but back then I hadn't a clue what it was. Now I know it was that iconic British invention, mainstay of Tomorrow's World on the BBC, the Hovercraft, that wonderful British go anywhere invention that ultimately went nowhere. Instead of floating on a cushion of air, this Corgi floats on three ball bearings on springs.

Corgi brought the hovercraft into the range in June 1960. It remained in production until 1962, there are no listed variations. I don't think it was a big seller in its day so they are not that common, however they are still not that sought after so you might get a bargain.

According to Wikipedia:

The Saunders-Roe SR.N1 ("Saunders-Roe Nautical 1") was the first practical hovercraft. It was designed by Christopher Cockerell and built by Saunders-Roe on the Isle of Wight under the auspices of the National Research and Development Corporation (NRDC). Powered by an Alvis Leonides radial piston engine that drove a lift fan, and using ducted air from the fan for propulsion, it first flew on 11 June 1959 in front of the assembled press showing its capability to cross both land and water.

On 25 July 1959, the 50th anniversary of Louis Blériot's cross-channel flight, the SR.N1 crossed the English Channel from Calais to Dover in just over two hours. The crew were Captain Peter Lamb (pilot), John Chaplin (navigator) and Christopher Cockerell, the inventor of the momentum curtain as applied to the hovercraft principle.

The SR.N1 later had a flexible skirt added in 1961 which greatly improved the effective depth of the air cushion. The following year an aft-facing Bristol-Siddeley Viper III jet engine, mounted on the rear of the decking behind the lift fan housing, supplemented the ducted-air propulsion produced by the piston engine, increasing the craft's maximum speed from 35 to 50 knots. The Viper installation followed an earlier installation of a Blackburn/Turbomeca Marboré of approximately half the Viper's thrust.

Models of the SR.N1 were available in both die-cast metal form in the Corgi Toys range, and as a 1:72 scale plastic construction kit from Airfix.

The SR.N1 is held by the Science Museum at Wroughton


Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119
Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119
Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119
Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119 Hovercraft SR.N1 - 1119

diecast.plus.com


Corgi 1960 Home Corgi Home Site Home